BS1363-1图5规|13A英式插头插脚尺寸量规|英国插头插销量规|Figure 5 gauge|Figure 5 Gauge for plug pins

BS1363-1图5规|13A英式插头插脚尺寸量规|英国插头插销量规|Figure 5 gauge|Figure 5 Gauge for plug pins

BS1363-1标准量规汇总清单方便查询：http://www.ag17.wang/product/BS1363-1_gauges.html

标准：符合BS1363-1:2012（或最新版）要求；

数量：1个。

使用：BS1363-1标准有多个章节要求使用图5量规确认插脚尺寸。

12.2.1 把量规放在一大概垂直向上的位置,使插头的插合面与量规互相平行,火线与中线铜脚 应插入到量规,其深度不超过2mm,然后施加一个与插合面垂直的不大于10N的力在插头中心上,且无额外的力用于调整铜脚,就能使得插头完全插入到量规中.

12.2.1 Compliance shall be checked by inspection, measurement and by the use of the gauge shown in Figure 5. For the gauging test rewirable plugs shall be fitted with a 3-core 1.25 mm2 flexible cord as given in Table 27 of BS 6500:2000. Non-rewirable plugs shall be tested as delivered.

With the gauge in an approximately vertical position and the engagement surfaces of the plug and the gauge parallel to each other, the line and neutral pins shall be entered into the gauge for a distance not exceeding 2 mm. The plug shall then enter the gauge fully when a force of 10 N or less is applied to the centre of the plug at right angles to the engagement surface and without any additional force being applied to the pins to bring them into alignment. In the case of plugs with ISODs, due to the flexibility of plastic materials some additional alignment of the ISOD is allowed when inserting into the Figure 5 gauge. Where alignment cannot be maintained the test given in BS 1363-2:2012, 13.8, shall be applied and the maximum withdrawal force from a socket-outlet conforming to BS 1363-2 shall not exceed 36 N.